|
Access 5.x |
Manual control > Manual control of the Actuators |
Caution: Manual control should exclusively be employed for testing and commissioning activities.
Modbus-controlled actuators (dampers) can be manually set to move and lock at desired positions.
Modbus connected actuators can only be controlled individually. This must be taken into account if more than one actuator is used by the function (e.g. Outdoor air damper in the high volume air handling units).
Manual control of the modbus connected actuators |
|||
Variable |
Available options & Selection |
Note |
|
Manual control of the Modbus connected actuator |
|||
Data & Settings > In-/Output status > Device status > Device 21 |
|||
Function |
Outdoor air damper |
Set actuator to the manual control mode Enter manual setpoint Wait while the actuator moves and check the value of the "Actual position" to match the new setpoint |
|
… |
… |
||
Actual position |
0% |
||
Device command |
| None | Reset device and clear errors | Manual control | |
||
Manual setpoint |
[0] % |
||