|
Access 5.x |
Dehumidification (Separate dehumidification unit) |
Access can control a single stage dehumidifier. The dehumidification is PID regulated to reduce the relative humidity in the room (or extract air) to the setpoint value. An analog output is used to control a dehumidifier. The output will increase on increasing room (or extract air) humidity. A digital output can also be used to start a dehumidifier.
note: this dehumidification can't be used in combination with humidification - sequence override should be used instead.
Configuration example of the dehumidification (control of a separate dehumidification unit) |
|||
Variable |
Available options & Selection |
Note |
|
Activate Humidity control |
|||
Configuration > Functions > Function activation |
|||
Humidity control |
... | Dehumidification |… |
||
Configure function |
|||
Configuration > Functions > Humidity control |
|||
Humidity control |
Dehumidification |
Indication of what function has been activated |
|
Select sequence for dehumidify |
| None | … |
Option used in case of sequence override dehumidification |
|
Type of output |
| Analog | Step | Analog + Step | |
| Analog | - 0..10V signal for capacity |Step| - relay output for start/stop |
|
PID Settings |
|||
Configuration > PID controllers > Dehumidification |
|||
P-band |
[100] %RH |
PID settings to describe responsiveness of the dehumidifier |
|
I-time |
[300] s |
||
D-time |
[0] s |
||
PID output max limit |
[100] % |
Max output of the PID can be limited |
|
Hardwired interface |
|||
Configuration > I/O allocation settings > |
|||
Analog inputs > Humidity room/extract air |
Any available I/O |
Mandatory - humidity sensor for reference |
|
Digital outputs > Humidity control start |
Interface to the dehumidifier |
||
Analog outputs > Humidity control |
|||
Operational settings |
|||
Data & Settings > Humidity control |
|||
Humidity room/extract air |
__ % |
Actual measured RH |
|
Setpoint humidity room/extract |
[50] %RH |
||
Digital output start point |
[15] % |
DO (Humidity control start) is activated once AO (Humidity control) exceeds 15% |
|
Digital output stop point |
[5] % |
DO (Humidity control start) is deactivated once AO (Humidity control) falls bellow 5% |
|
Operation overview |
|||
Data & Settings > Operation overview > Humidity |
|||
Humidity room/extract air |
__ % |
Overview of the function in action |
|
Setpoint humidity room/extract |
[50] %RH |
||
Humidity control |
__ % |
||
Humidity control start |
Off | On |
||
Humidity control mode |
Not active | Dehumidification |
||