|
Access 4.x |
Configuration |
To set up a function in the access controller you need to be logged in as Service to access the configuration menu.
Login step |
1 |
→ |
2 |
→ |
3 |
→ |
4 |
Action |
|
|
|
|
|||
Open the log in window |
Select service from drop down list |
Type in password 0612 |
Press Login |
After login quick configuration can be performed via configuration wizard (if enabled from the factory) or by following a 4-step procedure.
The usual configuration procedure includes "Activation" > "Configuration" > "Allocation" > "Operational settings".
Please note that not all functions require all four steps. The general procedure for setting up a function is described below.
This manual provides examples of the function configuration in a form of tables.
To recreate setup the configuration steps in the table should be followed top to bottom.
Configuration step |
Note |
|
Navigation path |
||
|
Activation |
|
Configuration > Functions > Function activation > |
||
Temperature control type |
Activate a function in a list of available functions (e.g. heater). |
|
Fan control type |
||
Heating/Cooling sequence setup |
||
Fan levels |
||
... |
||
|
Configuration |
|
Configuration > Functions > |
||
Temperature control |
Select the function's configuration (e.g. if heater is water, electric etc.). |
|
Fan control |
||
Fire/Smoke |
||
... |
||
|
Allocation |
|
Configuration > I/O allocation settings > |
||
Analog inputs > Outdoor temperature |
Select the function's configuration (e.g. if heater is water, electric etc.). Caution Do no use the same in- or output for several functions. |
|
Analog inputs > Supply temperature |
||
... |
||
Digital inputs > Extended operation |
||
Digital inputs > External alarm |
||
... |
||
Analog outputs > Heating (SEQ-A) |
||
Analog outputs > Exchanger (SEQ-B) |
||
... |
||
Digital outputs > Heating pump (SEQ-A) |
||
Digital outputs > Cooling pump (SEQ-C) |
||
... |
||
|
Operational settings |
|
Data & Settings > |
||
Temperature control > |
Setup how the function will work (e.g. setpoints, limits etc.) |
|
Fan control > |
||
Demand control > |
||
... |
||
Note: When the installation is complete and all functions are tested it is recommended to save a local backup of the current configuration in the control unit.
Select Yes on Save commissioning settings in the Configuration > System settings > Save and restore settings menu
Frequently used configuration guides:
Temperature control type (Room)
Air quality control (Fan start/stop)